Crossover distortion is a type of distortion which is caused by switching between devices driving a load. It is most commonly seen in complementary, or...

the exact nature of the distortion. Different types of distortion (like crossover distortion) are more audible than others (like soft clipping) even...

The total harmonic distortion (THD or THDi) is a measurement of the harmonic distortion present in a signal and is defined as the ratio of the sum of the...

of transistor sound, which had some negative connotations due to crossover distortion in early transistor amplifiers. However, solid state amplifiers have...

design, a peculiar form of crossover distortion known as low volume distortion (and historically given the terms "TDM distortion" and "ladder effect") is...

audiophiles mainly for their absence of crossover distortion and reduced odd-harmonic and high-order harmonic distortion. Class-A power amplifiers are also...

simultaneous reactants Crossover study, medical study with different treatments Crossover distortion, in electronics Chromosomal crossover, an exchange of genetic...

characteristics, distortion can be introduced as the two halves of the input waveform are amplified unequally. Crossover distortion can be created near...

for thermal stability, but are critical for minimizing crossover distortion. Least distortion is attained when the voltage drop across each emitter resistor...

one transistor to another (the crossover point), a small amount of distortion is created. "This crossover distortion is inevitable and although it can...

designed, they may enter limit cycles, resulting in non-linear distortion. This crossover type is mechanical and uses the properties of the materials in...

establishes the output stage in class AB operation and reduces the crossover distortion of this stage. A small differential input voltage signal gives rise...

Crossover thrash (often abbreviated to crossover) is a fusion genre of thrash metal and hardcore punk. The genre emerged in the mid-1980s, when hardcore...

1% distortion for audio-frequency signals. With negative feedback, distortion can typically be reduced to 0.001%. Noise, even crossover distortion, can...

the earlier valve amplifier designs were free of such artifacts as crossover distortion that beset the early bipolar transistor designs of the 1960s. Despite...

provide the full 35 milliamp 6L6GC plate current, thereby increasing crossover distortion. The 6505 is the base model of the series. It is identical to the...

YM2413 and YMF281 respectively. These variants also reduced the crossover distortion of the built-in DAC. A lower power consumption indicates that these...

are impractical for audio work because of high levels of distortion (See: Crossover distortion). In practical design, the result of a tradeoff is the class...

to B, open-loop crossover distortion worsens. Class AB and B amplifiers use NFB to reduce open-loop distortion. Measured distortion spectra from such...

required current capacity, so they go into various distortion modes, including crossover distortion, current / SOA clipping and slew limiting, with the...

THD, are questioned. For instance, crossover distortion at a given THD is much more audible than clipping distortion at the same THD, since the harmonics...

single-ended. Overall low harmonic distortion with small signals. By nature Class A amplifiers do not suffer from crossover distortion. Small roaming of anode bias...

the pull-up and pull-down transistors are biased to have minimal crossover distortion at room temperature, and the biasing is not temperature-compensated...

output pair, just biasing them into the conducting state so that crossover distortion is minimized. That is, the diodes push the output stage into class-AB...

remain stable at any possible combination of VX and VY. To avoid crossover distortion, A1 must have very high bandwidth and a fast slew rate but at treble...

distortion residue measurement) which has been claimed to correspond well with subjective effect even for power amplifiers where crossover distortion...

thereby reducing distortion in the drivers and interference between them. Crossovers can be passive or active. A passive crossover is an electronic circuit...

distortion. It is possible to use digital signal processing techniques to correct the group delay distortion that arises due to the use of crossover networks...

crossover network, either passive or active, filters the band of frequencies to be handled by the woofer and other speakers. Normally the crossover and...

reproduced by a stereo crossover and two or more subwoofers. Subwoofers are not acceptable to all audiophiles, likely due to distortion artifacts produced...