Locking hubs, also known as free wheeling hubs are fitted to some (mainly older) four-wheel drive vehicles, allowing the front wheels to rotate freely...

AC, manual locking hubs ST with electric windows, electric mirrors, central locking, carpet interior, AC, automatic locking hubs Ti (from late 1989)...

A center axle disconnect system or CAD is an alternative to locking hubs. CAD systems are typically used in front drive axles on four wheel drive vehicles...

and 4WD, with the latter featuring manually locking hubs on the S version and automatically locking hubs on the XS and top-of-the-line LS. Rear-wheel...

2019 at least 90 million vehicles use SKF wheel hub bearings. Locking hubs primechoiceautoparts.com, hub bearing assembly "SKF". Archived from the original...

torsion bar independent suspension, and permanent four-wheel drive with locking hubs. It had a wheelbase of 1,800 mm (71 in), a ground clearance of 280 mm...

with the full-time version of the Dana 44 that had no provision for locking hubs and had a front wheel bearing design with a somewhat dubious reputation...

for the car by CIMA. The CC8S uses magnesium alloy wheels with center-locking hubs, to which 225/40ZR 18" front and 335/40ZR 20" rear Michelin Pilot Sport...

have either two sealed automatic front axle locking hubs or two manual front axle hub selectors of "LOCK" and "UNLOCK" or "FREE". To engage the four-wheel-drive...

close-ratio four-speed. The Dana 30 front axle was retained, but the locking hubs were changed to a five-bolt retaining pattern versus the older six-bolt...

a manual, chain-driven transfer case floor shifter with manual front locking hubs, or an electronic shift-on-the-fly (a $185 option over the manual) dash...

manual locking hubs. Full-time four-wheel-drive pickups featured a two-speed New Process 203 transfer case with center differential and lock. Five positions...

driver to get out and lock the hubs when selecting the 4WD mode, but as of 1991 the F70/F80 switched to automatic locking hubs, engaging when the driver...

the "Jimny Sierra" rather than as the "Jimny Wide". The Jimny's vacuum-locking hubs allow it to be shifted from 2WD to 4WD while travelling at up to 100 km/h...

Manufacturing of Portland, Oregon to manufacture the bolt-on/bolt-off hubs. By 1954, the hubs were available as optional equipment through several major automakers...

Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana...

analogue being the front driveshaft of a part-time 4x4 truck without locking hubs). The Electronic Torque Split version of this all-wheel drive architecture...

design with manual locking hubs. The solid rear axles are available in semi-floating and full-floating variations. Selectable locking differentials (front...

locking variations. The housing material is Gray iron in early axles and Ductile iron in later axles. GM and Ford Dana 60 axles utilize locking hubs....

ISO 6697 Cycles – Hubs and freewheels – Assembly dimensions ISO 6698 Cycles – Screw threads used to assemble freewheels on bicycle hubs ISO 6699 Cycles –...

Four-wheel-drive improvements included the standardization of automatic locking hubs in 1989 and the availability of "Touch Drive" pushbutton activation,...

Beam. These trucks are distinguished by their significantly smaller locking hubs. As a running change during the 1994 model year, Ford revised the exterior...

with four-wheel drive; a shift-on the-fly Dana 20 transfer case and locking hubs were standard. The rear axle was a Ford 9-inch axle, with Hotchkiss drive...

1976: WABCO began the development of the anti-locking braking system on commercial vehicles to prevent locking on slippery roads, followed in 1986 by the...

adjacent to the transmission shifter. Both Aisin manual-locking and Isuzu's own auto-locking hubs were employed. In 1983, Isuzu introduced the five-door...

system that drove the front wheels through a solid front axle with manual locking hubs. The Hilux Surf was offered in two trim lines (SR and SSR), with either...

differential disconnect for the front differential (an alternative to automatic locking hubs). 1985 was the last year of the solid front axle in most markets. The...

with a manual-shift transfer case (the option was paired with manual-locking hubs). All Explorers were equipped with the Ford 8.8 axle in either a limited-slip...

self-reliance". The Svea Velocipede with vertical pedal arrangement and locking hubs was introduced in 1892 by the Swedish engineers Fredrik Ljungström and...

style centerlock hubs was patented by 1908. It was quickly adopted by auto manufacturers and racers. Although Rudge-Whitworth knock off hubs were excluded...