computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a SCSI command. The initiator usually does not provide...

physically cabling SCSI devices (like hard drives and tape changers), an iSCSI initiator sends SCSI commands over an IP network. An initiator falls into two...

act as a SCSI target. SCSI-1 and SCSI-2 have the option of parity bit error checking. Starting with SCSI-U160 (part of SCSI-3) all commands and data are...

communication takes place between an initiator and a target. The initiator sends a command to the target, which then responds. SCSI commands are sent in a Command...

presenting one or more Logical Unit Numbers (LUNs) to a SCSI initiator, receiving SCSI commands, and managing the input/output data transfers.[citation needed]...

the initiator, unless an expander is used. If one initiator is connected to one target, there is no opportunity for contention; with parallel SCSI, even...

returned by a SCSI device. When a SCSI target device returns a check condition in response to a command, the initiator usually then issues a SCSI Request Sense...

replication – Method of database replication SCSI initiator and target – Endpoint that initiates a SCSI command "Master–slave terminology alternatives...

LUN: In the early versions of SCSI, an initiator delivers a Command Descriptor Block (CDB) to a target (physical unit) and within the CDB is a 3-bit LUN...

the implementation to set priorities. Master/slave (technology) SCSI initiator and target How Bus Mastering Works - Tweak3D What is bus mastering?- Brevard...

from target to initiator) or a write (data sent from an initiator to target). PCI targets must examine the command code as well as the address and not...

and an initiator (a client accessing the target) with the target initiating data transfers. In other words, when an initiator writes data to a target...

host system and a peripheral SCSI device or storage system. These adapters manage service and task communication between the host and target. Typically...

SCSI ports: initiator ports, target ports and target/initiator ports. A SCSI device may contain any combination of initiator ports, target ports and target/initiator...

SCSI Enclosure Services (SES) is a protocol for more modern SCSI enclosure products. An initiator can communicate with the enclosure using a specialized...

gateway devices, and cables. SAN network devices move data within the SAN, or between an initiator, such as an HBA port of a server, and a target, such as the...

for processing SCSI commands. Target drivers which receive SCSI commands from a SCSI initiator, pass these SCSI to the SCST core and send back replies...

TFTP, AFP, rsync, Unison (file synchronizer), iSCSI (initiator and target), HAST, CARP, Bridge, UPnP, and BitTorrent. All of this is configurable through...

remote workstations and DAEMON Tools iSCSI Target 2 – a cross-platform solution that enables creating an iSCSI storage server and provides access to virtual...

that cannot be completed immediately is postponed by either the target or the initiator issuing retry-cycles, during which no other agents can use the...

copying on the target and initiator. The Datamover Architecture (DA) defines an abstract model in which the movement of data between iSCSI end nodes is...

July 2011. StarWind Free AoE Initiator for Microsoft Windows WinAoE Driver: A bootable, open source AoE initiator, EOL-ed and phased out by WinVBlock successor...

Service (iSNS) protocol allows automated discovery, management and configuration of iSCSI and Fibre Channel devices (using iFCP gateways) on a TCP/IP network...

technologies including Fibre Channel, Parallel ATA, Serial ATA, SCSI and Serial Attached SCSI (SAS). A WWN may be employed in a variety of roles, such as...

originates (or is driven by) an initiator, typically a host bus adapter or SAS (Serial_Attached_SCSI) Expander, and arrives at a target, typically a backplane...

controller SCSI target. On the VPLEX back end, the VPLEX provides an interface to a physical storage controller that act like a host, essentially like a SCSI initiator...

audio and mouse ports - along with floppy and hard drive controllers. SCSI ports and drives, a CD-ROM drive, modem ports, internally fitted modems, and an...

third indicate Locate and Fail. The SGPIO bus consists of 4 signal lines and originates at the HBA, referred to as the initiator and ends at a back-plane...

from the original on 2016-10-18. Retrieved 2016-10-18. ...  TCP 12975 (initiator port) TCP 32976 (session port) If the above ports cannot be used to achieve...

addresses in the initiator's FireWire Physical Address Space, which the target is supposed to use for moving I/O data to and from the initiator. On many implementations...