The signal-to-interference ratio (SIR or S/I), also known as the carrier-to-interference ratio (CIR or C/I), is the quotient between the average received...

engineering, the signal-to-interference-plus-noise ratio (SINR) (also known as the signal-to-noise-plus-interference ratio (SNIR)) is a quantity used to give theoretical...

telecommunications, the carrier-to-noise ratio, often written CNR or C/N, is the signal-to-noise ratio (SNR) of a modulated signal. The term is used to distinguish the...

from interference, for example in the signal-to-noise ratio (SNR), signal-to-interference ratio (SIR) and signal-to-noise plus interference ratio (SNIR)...

Signal-to-noise ratio (SNR or S/N) is a measure used in science and engineering that compares the level of a desired signal to the level of background...

Distortion Inter-flow interference Intra-flow interference Meaconing Signal-to-interference ratio (SIR) Signal-to-noise plus interference (SNIR) "2015 National...

narrowband interference, as the interference is not subject to the process gain of the DSSS signal, and hence the signal-to-interference ratio is improved...

called destructive interference. Modern active noise control is generally achieved through the use of analog circuits or digital signal processing. Adaptive...

Diversity gain is the increase in signal-to-interference ratio due to some diversity scheme, or how much the transmission power can be reduced when a...

= output signal to interference ratio. ρ r e f ( z )   {\displaystyle \rho _{\mathsf {ref}}(z)\ } = reference signal to interference ratio. z   {\displaystyle...

Attenuation-to-crosstalk ratio Audio system measurements Print-through Signal integrity Signal-to-interference ratio (SIR or S/I), also known as carrier-to-interference...

utilization Spectral efficiency Signal-to-noise ratio in decibel measures: signal-to-interference ratio, Eb/N0 Bit error rate (BER), packet error rate...

Turajlic SR (October 2005). "Application of the maximum signal to interference ratio criterion to the adaptive microphone array". Acoustics Research Letters...

voltage. Common-mode interference (CMI) is a type of common-mode signal. Common-mode interference is interference that appears on both signal leads, or coherent...

lead to interference. Adjacent-channel interference Broadcast signal intrusion Signal-to-interference ratio (SIR or S/I), also known as Carrier-to-interference...

of multiple received signals into a single improved signal Diversity gain, the increase in signal-to-interference ratio due to a diversity scheme Diversity...

fading - Shadow loss - shortwave relay station - side lobe - Signal-to-Interference Ratio - single event upset (SEU) - Single vegetative obstruction model...

in which a signal that is 180-degrees out-of-phase of the noise is presented, which in theory cancels the noise. Canal caps are similar to earplugs in...

stream over a communication channel that have been altered due to noise, interference, distortion or bit synchronization errors. The bit error rate (BER)...

and rolling road dynamometers. Typically, signals are recorded directly to the hard drive via an analog-to-digital converter. In the past, magnetic or...

of a circuit to isolate an undesired signal component from the desired signal component, as with common-mode rejection ratio. All signal processing devices...

Adjacent-channel interference (ACI) is interference caused by extraneous power from a signal in an adjacent channel. ACI may be caused by inadequate filtering...

algorithm Signal-to-interference ratio, in telecommunication, the ratio of useful signal versus co-channel interference received Short interest ratio, a metric...

referred to as anisotropic diffusion by Perona and Malik even though the locally adapted filter is isotropic, but it has also been referred to as inhomogeneous...

{\displaystyle E_{b}/N_{0}} (energy per bit to noise power spectral density ratio) is a normalized signal-to-noise ratio (SNR) measure, also known as the "SNR...

allows the object range to be easily calculated and for a matched filter to be used to achieve an optimal signal-to-noise ratio in the receiver. A passive...

sound barrier, or acoustical barrier) is an exterior structure designed to protect inhabitants of sensitive land use areas from noise pollution. Noise...

through a speaker, causing destructive interference and canceling much of the noise. Residential sound programs aim to decrease or eliminate the effects of...

In telecommunications, intersymbol interference (ISI) is a form of distortion of a signal in which one symbol interferes with subsequent symbols. This...

technique, often used to remove noise from an image, signal, and video. Such noise reduction is a typical pre-processing step to improve the results of...