A wire signal is a brevity code used by telegraphers to save time and cost when sending long messages. The best-known code was the 92 Code adopted by...

technology, an analog type of audio storage. It recorded sound signals on a thin steel wire using varying levels of magnetization. The first crude magnetic...

logic signals, aka lines or wires, to support full duplex communication. It is sometimes called a four-wire serial bus to contrast with three-wire variants...

sourced clock signal arrives at different components at different times due to gate or, in more advanced semiconductor technology, wire signal propagation...

Single-ended signaling is the simplest and most commonly used method of transmitting electrical signals over wires. One wire carries a varying voltage...

magnetic fields that induce a smaller signal in neighboring wires. In electrical circuits sharing a common signal return path, electrical impedance in...

cross-sectional area. Wires are used to bear mechanical loads, often in the form of wire rope. In electricity and telecommunications signals, wire can refer to...

Corps of Signals (often simply known as the Royal Signals – abbreviated to R SIGNALS) is one of the combat support arms of the British Army. Signals units...

The Signal Protocol (formerly known as the TextSecure Protocol) is a non-federated cryptographic protocol that provides end-to-end encryption for voice...

codes, including such notable ones as 10-4 Phillips Code NOTAM Code Wire signal, Morse Code abbreviation, also known as 92 Code. Appears in informal...

Wired. Condé Nast. Retrieved 21 February 2018. Lund, Joshua (27 November 2019). "Signal for iPad, and other iOS improvements". Signal.org. Signal Messenger...

rubber. The two wires are electrically identical, but are marked to identify the correct audio signal polarity. Most commonly, speaker wire comes in the...

and an unfiltered wire are used). A baseband processor also known as BP or BBP is used to process the down-converted digital signal to retrieve essential...

electronics, a signal trace or circuit trace on a printed circuit board (PCB) or integrated circuit (IC) is the equivalent of a wire for conducting signals. Each...

is the time duration taken for a signal to reach its destination, for example in the electromagnetic field, a wire, gas, fluid or solid body. An electromagnetic...

electrical signal as a differential pair of signals, each in its own conductor. The pair of conductors can be wires in a twisted-pair or ribbon cable or traces...

non-overlapping pulses. Traditionally one wire is called "phase 1" or "φ1" (phi1), the other wire carries the "phase 2" or "φ2" signal. Because the two phases are guaranteed...

that was developed by the Associated Press wire service. Telegraph operators familiar with numeric wire signals such as the 92 Code used these railroad codes...

A wire-guided missile is a missile that is guided by signals sent to it via thin wires connected between the missile and its guidance mechanism, which...

are for the signal conductors. The signal wires can carry two copies of the same signal with opposite polarity (differential signalling) but need not...

changed the commands on the signal to direct traffic. In 1912, the first electric traffic light was developed by Lester Wire, a policeman in Salt Lake City...

converts the DC signaling protocol into tones that could be transmitted over a four-wire link back to the PTT exchange. The signaling unit and trunk circuit...

are abbreviations such as WX for weather and SX for dollar, and from wire signal codes, the numbers 73 for best regards and 88 for love and kisses. These...

are dependent on the pilot's actions. The term "fly-by-wire" implies a purely electrically signaled control system. It is used in the general sense of computer-configured...

Telegraph & Telephone Age. 1925 Morse code Morse code abbreviations Wire signal Scribal abbreviation List of shorthand systems Phillips, Walter P. (1975)...

converts the sounds into an electrical signal. The signal is transmitted to the receiving telephone by wires; at the receiver it is reconverted into...

A single-wire transmission line (or single wire method) is a method of transmitting electrical power or signals using only a single electrical conductor...

the process of sending or propagating an analog or digital signal via a medium that is wired, wireless, or fiber-optic. Transmission system technologies...

referenced to the local common or ground, a common-mode signal appears on both lines of a two-wire cable, in phase and with equal amplitudes. Technically...

have a termination resistor connected across the two wires. Without termination resistors, signal reflections off the unterminated end of the cable can...