A switching loop or bridge loop occurs in computer networks when there is more than one layer 2 path between two endpoints (e.g. multiple connections...

In telephony, a Switched loop is a circuit that automatically releases a connection from an attendant console or switchboard, once the connection has...

trick switches or hosts into sending data to a machine even if it is not intended for it, scalability and security issues with regard to switching loops, broadcast...

Most commonly the cause is a switching loop in the Ethernet network topology (i.e. two or more paths exist between switches). A simple example is both ends...

a switch-within-a-loop. The loop-switch sequence is a specific derivative of spaghetti code. It is not necessarily an antipattern to use a switch statement...

A network switch (also called switching hub, bridging hub, Ethernet switch, and, by the IEEE, MAC bridge) is networking hardware that connects devices...

input command or process setpoint. There are many open-loop controls, such as on/off switching of valves, machinery, lights, motors or heaters, where...

a switch or pulling a plug. It may be intentional. There is no general algorithm to determine whether a computer program contains an infinite loop or...

a switching loop resulting in broadcast radiations and MAC table instability.: 388  If redundant links are used to connect switches, then switching loops...

of loop prevention and only implement mitigations such as split horizon, route poisoning, and holddown timers. Switching loop "What is Routing Loop and...

action is the switching on/off of the boiler, but the controlled variable should be the building temperature, but is not because this is open-loop control of...

without the need of manually enabling backup links and getting rid of switching loop danger. Moreover, MSTP allows frames/packets assigned to different VLANs...

switching loops. Unidirectional Link Detection (UDLD) is one of two major features (UDLD and loop guard) in Cisco Switches to prevent Layer 2 loops....

A switched-mode power supply (SMPS), also called switching-mode power supply, switch-mode power supply, switched power supply, or simply switcher, is...

packet switching, the bandwidth of the transmission medium is shared between multiple communication sessions, in contrast to circuit switching, in which...

way of manually implementing loop unrolling by interleaving two syntactic constructs of C: the do-while loop and a switch statement. Its discovery is credited...

Tree Protocol which blocks any redundant paths that could result in a switching loop. SPB allows all paths to be active with multiple equal-cost paths. SPB...

Distributed switching is an architecture in which multiple processor-controlled switching units are distributed. There is often a hierarchy of switching elements...

In electrical signalling an analog current loop is used where a device must be monitored or controlled remotely over a pair of conductors. Only one current...

Ring Protection Switching (ERPS) is an effort at ITU-T under G.8032 Recommendation to provide sub-50ms protection and recovery switching for Ethernet traffic...

Phenotypic switching is switching between multiple cellular morphologies. David R. Soll described two such systems: the first high frequency switching system...

The arbitrated loop, also known as FC-AL, is a Fibre Channel topology in which devices are connected in a one-way loop fashion in a ring topology. Historically...

variant of burst switching used in optical networks is optical burst switching. Examples of technology using burst switching include: EtherLoop, used after...

lines from the serving switching center, which usually does not require the assistance of personnel at the served terminal. Loop around is a method of...

signaling technology in telecommunications in which a direct current local loop circuit is interrupted according to a defined coding system for each signal...

loss of loop current. Interruption of loop current is variously called open loop disconnect, or an open switching interval. Additional types of loop signaling...

variables used by a nested loop. The variable used in the inner loop switches to the outer loop, and vice versa. It is often done to ensure that the elements...

A passing loop (UK usage) or passing siding (North America) (also called a crossing loop, crossing place, refuge loop or, colloquially, a hole) is a place...

action is the switching on/off of the boiler, but the controlled variable should be the building temperature, but is not because this is open-loop control of...

American countries on analog loop start trunks Analog Open Switching Interval (OSI) - Used in North America on analog loop start trunks Digital ISDN -...