The metal–oxide–semiconductor field-effect transistor (MOSFET, MOS-FET, or MOS FET) is a type of field-effect transistor (FET), most commonly fabricated...

A power MOSFET is a specific type of metal–oxide–semiconductor field-effect transistor (MOSFET) designed to handle significant power levels. Compared to...

properties of MOSFETs allowed them to capture nearly all market share for digital circuits in the 1970s. Discrete MOSFETs (typically power MOSFETs) can be applied...

comes in two types: junction FET (JFET) and metal-oxide-semiconductor FET (MOSFET). FETs have three terminals: source, gate, and drain. FETs control the flow...

The floating-gate MOSFET (FGMOS), also known as a floating-gate MOS transistor or floating-gate transistor, is a type of metal–oxide–semiconductor field-effect...

The MOSFET (metal–oxide–semiconductor field-effect transistor) is a type of insulated-gate field-effect transistor (IGFET) that is fabricated by the controlled...

after the power MOSFET.[citation needed] An IGBT cell is constructed similarly to an n-channel vertical-construction power MOSFET, except the n+ drain...

MOSFET gate driver is a specialized circuit that is used to drive the gate (gate driver) of power MOSFETs effectively and efficiently in high-speed switching...

Bell Labs in 1959. MOSFETs use even less power, which led to the mass-production of MOS transistors for a wide range of uses. The MOSFET has since become...

The EKV Mosfet model is a mathematical model of metal-oxide semiconductor field-effect transistors (MOSFET) which is intended for circuit simulation and...

specialised applications. The MOSFET (MOS transistor) was invented by Mohamed Atalla and Dawon Kahng at Bell Labs in 1959. The MOSFET was the first truly compact...

the MOSFET (MOS field-effect transistor, or MOS transistor) invented by Mohamed M. Atalla and Dawon Kahng in 1959, and demonstrated in 1960. MOSFET sensors...

multi-gate MOSFET or multi-gate field-effect transistor (MuGFET) refers to a metal–oxide–semiconductor field-effect transistor (MOSFET) that has more...

electronic amplifier in which the amplifying devices (transistors, usually MOSFETs) operate as electronic switches, and not as linear gain devices as in other...

most common type of FET amplifier is the MOSFET amplifier, which uses metal–oxide–semiconductor FETs (MOSFETs). The main advantage of a FET used for amplification...

of the power MOSFET. Some common power devices are the power MOSFET, power diode, thyristor, and IGBT. The power diode and power MOSFET operate on similar...

for radiotherapy radiation beams. The main advantages of MOSFET devices are: 1. The MOSFET dosimeter is direct reading with a very thin active area (less...

low cost alternative to FinFETs. An SOI MOSFET is a metal–oxide–semiconductor field-effect transistor (MOSFET) device in which a semiconductor layer such...

circuit can also be built using bipolar transistors, or MOSFETs, or even one FET (or MOSFET) and one BJT. This circuit arrangement was very common in...

minimized by selecting MOSFETs with low gate charge, by driving the MOSFET gate to a lower voltage (at the cost of increased MOSFET conduction losses), or...

the MOSFET. Consequently, the diodes in the Dickson multiplier are often replaced with MOSFETs wired to behave as diodes. The diode-wired MOSFET version...

field-effect transistor (MOSFET) fabrication process that uses complementary and symmetrical pairs of p-type and n-type MOSFETs for logic functions. CMOS...

switching. An SSR based on a single MOSFET, or multiple MOSFETs in a paralleled array, can work well for DC loads. MOSFETs have an inherent substrate diode...

The PSU typically uses a switched-mode power supply (SMPS), with power MOSFETs (power metal–oxide–semiconductor field-effect transistors) used in the...

applications. MOSFET dosimeters are now used as clinical dosimeters for radiotherapy radiation beams. The main advantages of MOSFET devices are: 1. The MOSFET dosimeter...

For power semiconductor devices (such as BJT, MOSFET, thyristor or IGBT), the safe operating area (SOA) is defined as the voltage and current conditions...

P-channel MOSFETs connected to the high voltage bus and NPN BJTs or N-channel MOSFETs connected to the low voltage bus. The most efficient MOSFET designs...

working in the field. In 1974, Robert H. Dennard at IBM recognized the rapid MOSFET scaling technology and formulated what became known as Dennard scaling,...

In semiconductor electronics, Dennard scaling, also known as MOSFET scaling, is a scaling law which states roughly that, as transistors get smaller, their...

MOSFET mirrors because MOSFETs have rather low intrinsic output resistance values. A MOSFET version of Figure 3 is shown in Figure 4, where MOSFETs M3...