CONFIG.SYS is the primary configuration file for the DOS and OS/2 operating systems. It is a special ASCII text file that contains user-accessible setup...

Windows 9x. CONFIG.SYS is a text file that contains various configuration options and specifies what device drivers will be loaded. COUNTRY.SYS is a binary...

in CONFIG.SYS. In DR DOS 5.0 (1990) and 6.0 (1991), the driver is named HIDOS.SYS rather than HIMEM.SYS, like the corresponding DCONFIG.SYS or CONFIG.SYS...

primarily relied on the CONFIG.SYS config file; a plain text file with simple key–value pairs (e.g. DEVICEHIGH=C:\DOS\ANSI.SYS). MS-DOS 6 introduced the...

Windows Me ignores this. If the CONFIG.SYS file does not exist, the IO.SYS file loads the drivers IFSHLP.SYS, HIMEM.SYS and SETVER.EXE. Windows reserves...

system files IO.SYS and MSDOS.SYS were combined into a single file IO.SYS whilst MSDOS.SYS became a configuration file similar to CONFIG.SYS and AUTOEXEC...

in CONFIG.SYS, and programs were loaded in the AUTOEXEC.BAT file. Some devices, such as mice, could be loaded either as a device driver in CONFIG.SYS, or...

time. This can be emulated under DR-DOS by utilizing the CONFIG.SYS directive SET like SET CONFIG=1. %CMDLINE% (introduced with 4DOS, also supported since...

available. Processes the MSDOS.SYS file with Windows 9x. Processes the CONFIG.SYS file, in MS-DOS 2.0 and higher and Windows 9x. Loads COMMAND.COM (or other...

versions 3.1 and later and IBM PC DOS releases 3 and later. Used in the CONFIG.SYS file to set the maximum number of drives that can be accessed. The command...

let the hook run. A 16-bit driver called IFSMGR.SYS would previously have been loaded by CONFIG.SYS, the job of which was to hook MS-DOS first before...

code itself is required and it is loaded via an "IFS=" statement in the CONFIG.SYS file. It is a NE 16-bit dynamically loaded library. No matter if it is...

loaded in CONFIG.SYS via DEVICE statements, e.g. RAM disks. Assign subsequent drive letters to any dynamically loaded drives via CONFIG.SYS INSTALL statements...

NANSI.SYS and ANSIPLUS.EXE to attempt to change this.[independent source needed] To use ANSI.SYS under DOS, a line is added to the CONFIG.SYS (or CONFIG.NT...

Early versions of SmartDrive were loaded through a CONFIG.SYS device driver named SMARTDRV.SYS. Versions 4.0 and later were loaded through an executable...

Klangstabil feat. S.alt, Somatic Responses, Hypnoskull, Winterkälte, Config.Sys, Tarmvred, Roger Rotor, Deutsch Nepal, Placid, Panacea vs. Needle Sharing...

files, CONFIG.SYS and AUTOEXEC.BAT, is bypassed at startup and essential real mode drivers like HIMEM.SYS and SMARTDRV.EXE are embedded into IO.SYS. The...

loading of an appropriate CD-ROM device driver (example: OAKCDROM.SYS), usually from CONFIG.SYS. The final version of the MSCDEX program was 2.25,[citation...

long as Scroll Lock remains activated. DR-DOS 7.02 and higher provides a CONFIG.SYS directive named SCROLLOCK=ON|OFF to change the Scroll Lock status on the...

illusion of frozen, or slowly progressing, time in motion video TIMESLICE, a CONFIG.SYS configuration directive in OS/2 A Slice at a Time, science fiction story...

or security), displays boot menus, processes configuration files (like CONFIG.SYS) and launches the shell (like COMMAND.COM). The file is part of IBM's...

(with DEBUG=ON and a debugger loaded before or from within CONFIG.SYS) and more flexible CONFIG.SYS tracing capabilities via the F5/F6/F7/F8 hotkeys and the...

config.sys + autoexec.bat or hold F8 so DOS prompt Y/N to confirm each line in config.sys and autoexec.bat; allowing you to skip loading qemm386.sys,...

file type. For example, COUNTRY.SYS is not a DOS device driver, but a binary NLS database file for use with the CONFIG.SYS COUNTRY directive and the NLSFUNC...

to: install (Unix), a command line tool for installing files INSTALL, a CONFIG.SYS directive Installation (disambiguation) This disambiguation page lists...

introduced the HIMEM.SYS device driver. Starting in 1990 with Digital Research's DR DOS 5.0 (via HIDOS.SYS /BDOS=FFFF and CONFIG.SYS HIDOS=ON) and since...

in Unix), the output of Autotools; used to detect system configuration CONFIG.SYS, the primary configuration file for DOS and OS/2 operating systems Configuration...

codes at least in CONFIG.SYS. With 4DOS and DR-DOS COMMAND.COM, exit codes (in batchjobs) can be set by EXIT n and (in CONFIG.SYS) through ERROR=n. Exit...

changed and overridden using the LPT1, LPT2, LPT3 (and optionally LPT4) CONFIG.SYS directives. DOS-based systems make the logical parallel ports detected...

The magic SysRq key is a key combination understood by the Linux kernel, which allows the user to perform various low-level commands regardless of the...