Color Light Output (CLO), also known as Color Brightness, is a specification that provides information on a projector’s ability to reproduce color. Color...

Brightness (white light output) measures the total amount of light projected in lumens. The color brightness specification Color Light Output measures red...

with electron holes, releasing energy in the form of photons. The color of the light (corresponding to the energy of the photons) is determined by the...

Color temperature is a parameter describing the color of a visible light source by comparing it to the color of light emitted by an idealized opaque,...

Color vision, a feature of visual perception, is an ability to perceive differences between light composed of different frequencies independently of light...

technology Optimum HDTV viewing distance High Dynamic Range (HDR) Color Light Output Flexible display Comparison of CRT, LCD, plasma, and OLED displays...

Suriname Collateralized loan obligation, an asset-backed security Color Light Output or color brightness of a projector Alberto Clò (born 1947), Italian politician...

The RGB color model is an additive color model in which the red, green, and blue primary colors of light are added together in various ways to reproduce...

flexible, and the light output and spatial distribution of an LED array can be controlled with no efficiency loss. LEDs using the color-mixing principle...

aim of color calibration is to measure and/or adjust the color response of a device (input or output) to a known state. In International Color Consortium...

Though color is not an inherent property of matter, color perception is related to an object's light absorption, reflection, emission spectra, and interference...

intense illumination. The light source is commonly a xenon flash lamp, or flashtube, which has a complex spectrum and a color temperature of approximately...

An output device is any piece of computer hardware that converts information or data into a human-perceptible form or, historically, into a physical machine-readable...

process, referred to as color timing, was performed at a film lab during printing by varying the intensity and color of light used to expose the rephotographed...

colours (see below). When using a direct-drive monitor, the four color bits are output directly to the DE-9 connector at the back of the card. Within the...

the perceived color of the light emitted by CFLs, so that some sources rate the best "soft white" CFLs as subjectively similar in color to standard incandescent...

output and 2D blended output) Used internally by many LCD monitors Often known as truecolor and millions of colors, 24-bit color is the highest color...

colors are produced either by placing a color wheel between a white lamp and the DLP chip or by using individual light sources to produce the primary colors...

projectors can have higher color light output than single-chip DLP projectors. This is because 3LCD projectors mix and project the light beams from all three...

the light will normally decrease efficacy but increase the directionality and the visual comfort probability. Color temperature for white light sources...

In four-color printing (or more), under color addition (UCA) is a technique for darkening areas of the printed image by adding colored inks. It is meant...

shunts, and driving light-emitting diode (LED) status indicators. In the latter case, a GPIO can, in many cases, supply enough output current to directly...

coloration may cause the color of objects to lie outside the optimal color solid) The reflectance spectrum of a color is the amount of light of each wavelength...

the panel there is an analog/digital audio output. The XEL-1 has a contrast ratio of 1,000,000:1, high color saturation, large viewing angles, high screen...

angled facets similar to a jewel or fresnel lens can increase light output by distributing light perpendicular to the chip surface and far to the sides of...

seven minutes to reach full light output. Mercury-vapor lamps are becoming obsolete due to the higher efficiency and better color balance of metal halide...

only of showing shades of gray. In color photography, electronic sensors or light-sensitive chemicals record color information at the time of exposure...

compounds in the quartz arc tube, which improve the efficiency and color rendition of the light. The most common metal halide compound used is sodium iodide...

is that they have an improved light absorption characteristic; that is, their quantum efficiency is higher. The raw output of Bayer-filter cameras is referred...

sodium lamps emit a broader spectrum of light than the low-pressure lamps, but they still have poorer color rendering than other types of lamps. Low-pressure...