The edge connector is a money-saving device because it only requires a single discrete female connector (the male connector is formed out of the edge of...

power connector Computer port (hardware) Crocodile clip DC connector DIN connector Dock connector D-sub connectors Edge connector Elastomeric connector IEC...

slot through an edge connector, though some, such as NLX and Next Unit of Computing Extreme, instead are plugged into an edge connector on the mainboard...

March 2019. "[Video output connector uses DB-15 used by analog VGA monitors, output connector uses RCA stereo connectors]" (PDF). Archived from the original...

rectangular, with an edge connector on one side and a semicircular mounting hole at the center of the opposite edge. The edge connector has 75 positions with...

(to act as a compass and metal detector). MicroUSB connector, battery connector, 25-pin edge connector. Display consisting of 25 LEDs in a 5×5 array. Three...

graph theory, an edge-graceful labeling is a type of graph labeling for simple, connected graphs in which no two distinct edges connect the same two distinct...

16-pin gold plated edge connector. Double-width cards are 5.375 inches wide by 4.5 inches tall, with two 16-pin gold plated edge connectors. Contacts are labeled...

multi-pin connectors are relatively costly, some mass-market systems such as home computers had no expansion slots and instead used a card-edge connector at...

A Molex connector is a two-piece pin-and-socket interconnection which became an early electronic standard. Developed by Molex Connector Company in the...

memory module has a flat edge connector at the bottom, while production DDR4 DIMM modules have a slightly curved edge connector so not all of the pins are...

backplane since as well as the standard x16 edge connector it had an auxiliary extension edge connector. This element was launched November 2022 and...

Connection to the computer is done via a proprietary edge connector (Commodore 1530) or mini-DIN connector (1531). The absence of recordable audio signals...

and electrical specification for the 330-lead Single Edge Contact Cartridge (or edge-connector) used by Intel's Pentium II Xeon and Pentium III Xeon...

Express connector should not be confused with the EPS12V connector, which is mainly used for powering SMP and multi-core systems. The power connectors are...

output via an RCA connector. The used channel could be adjusted from number 36 with the potentiometer to the left. 8-pin DIN connector containing composite...

signal interface uses a 50-pin PCB edge connector which mates to a flat ribbon cable connector. Separate connectors are provided for both AC and DC power...

The card connector used for each type include: Type I and II use a 100-pin stacking connector, while Type III uses a 124-pin edge connector, i.e. the...

Slot 1 refers to the physical and electrical specification for the connector used by some of Intel's microprocessors, including the Pentium Pro, Celeron...

use the twenty-pin SFF-8784 edge connector to save space. By combining the data signals and power lines into a slim connector that effectively enables direct...

cassette connector. Optionally, an extra 16 or 32 KB of RAM can be installed and a daughterboard with an RS-232 port. The 40-conductor expansion connector passes...

their peripherals using the IEEE 488 bus, but with a non-standard card edge connector. Commodore's following 8-bit machines utilized a serial bus whose protocol...

specification for a 242-lead single-edge-connector used by early versions of AMD's Athlon processor. The Slot A connector allows for a higher bus rate than...

upper reaches of the machine's unique (non-ASCII) character set. The edge connector or external interface at the rear of the ZX81 is an extension of the...

North America. The Type 2 connector was adopted as the EU standard in 2013, with full compliance required by 2025. The connector was chosen by the EU to...

A dock connector is an electrical connector used to attach a mobile device simultaneously to multiple external resources. Dock connectors typically carry...

multiple edges: Edges without own identity: The identity of an edge is defined solely by the two nodes it connects. In this case, the term "multiple edges" means...

design due to cost saving measures, adding the "missing" D-sub connector onto an edge connector. This would also provide much necessary protection as frequent...

edge connector in-line with the eight-bit XT-bus connector, which is unchanged, retaining compatibility with most 8-bit cards. The second connector adds...

device inputs and outputs are through five ring connectors that are part of the 23-pin edge connector. BPI:bit provides a wide range of onboard resources...