employing transistors, it is necessary to scientifically model the physical phenomena observed in their operation using transistor models. There exists...

junction transistor (BJT) is a type of transistor that uses both electrons and electron holes as charge carriers. In contrast, a unipolar transistor, such...

A transistor is a semiconductor device used to amplify or switch electrical signals and power. It is one of the basic building blocks of modern electronics...

In a diode model two diodes are connected back-to-back to make a PNP or NPN bipolar junction transistor (BJT) equivalent. This model is theoretical and...

metal–oxide–semiconductor field-effect transistor (MOSFET, MOS-FET, MOS FET, or MOS transistor) is a type of field-effect transistor (FET), most commonly fabricated...

A transistor radio is a small portable radio receiver that uses transistor-based circuitry. Previous portable radios used vacuum tubes, which were bulky...

The Gummel–Poon model is a model of the bipolar junction transistor. It was first described in an article published by Hermann Gummel and H. C. Poon at...

field-effect transistor (MuGFET) refers to a metal–oxide–semiconductor field-effect transistor (MOSFET) that has more than one gate on a single transistor. The...

An insulated-gate bipolar transistor (IGBT) is a three-terminal power semiconductor device primarily forming an electronic switch. It was developed to...

circuit model used for analyzing the small signal behavior of bipolar junction and field effect transistors. Sometimes it is also called Giacoletto model because...

In 1955, Philco developed and produced the world's first all-transistor phonograph models TPA-1 and TPA-2, which were announced in the June 28, 1955 edition...

Non-Quasi Static model (NQS) is a transistor model used in analogue/mixed signal IC design. It becomes necessary to use an NQS model when the operational...

An avalanche transistor is a bipolar junction transistor designed for operation in the region of its collector-current/collector-to-emitter voltage characteristics...

Transistor–transistor logic (TTL) is a logic family built from bipolar junction transistors (BJTs). Its name signifies that transistors perform both the...

as a floating-gate MOS transistor or floating-gate transistor, is a type of metal–oxide–semiconductor field-effect transistor (MOSFET) where the gate...

BSIM (Berkeley short-channel IGFET model) refers to a family of MOSFET transistor models for integrated circuit design. It also refers to the BSIM group...

diodes, varistors, LEDs, JFETs, MOSFETs and so on). Qucs supports transistor models, some need to be added by hand. Some have been tested, these include...

simulators Input/output Buffer Information Specification (IBIS) SPICE OPUS Transistor model Nagel, Laurence W.; Pederson, D. O (April 1973). SPICE (Simulation...

the transistor prematurely. The origin of the threshold decrease can be understood as a consequence of charge neutrality: the Yau charge-sharing model. The...

The EKV Mosfet model is a mathematical model of metal-oxide semiconductor field-effect transistors (MOSFET) which is intended for circuit simulation and...

1966-Pao-Sah journal articles on MOS transistor models, in order to help further in the development of compact models for computer aided design of nanometer...

current is the current between the source and drain of a MOSFET when the transistor is in subthreshold region, or weak-inversion region, that is, for gate-to-source...

The field-effect transistor (FET) is a type of transistor that uses an electric field to control the current through a semiconductor. It comes in two types:...

In electronics, short-channel effects occur in MOSFETs in which the channel length is comparable to the depletion layer widths of the source and drain...

stand-off ratio"). The 2N2646 model is the most commonly used version of the UJT. The complementary unijunction transistor, or CUJT, is a bar of p-type...

threshold voltage, commonly abbreviated as Vth or VGS(th), of a field-effect transistor (FET) is the minimum gate-to-source voltage (VGS) that is needed to create...

The point-contact transistor was the first type of transistor to be successfully demonstrated. It was developed by research scientists John Bardeen and...

the all-transistor portable 45rpm phonograph models, for transistors were too expensive compared to vacuum tubes. The Philco Transac models S-1000 scientific...

A fin field-effect transistor (FinFET) is a multigate device, a MOSFET (metal–oxide–semiconductor field-effect transistor) built on a substrate where the...

devices. It may also include the creation of compact models (such as the well known SPICE transistor models), which try to capture the electrical behavior of...