In telecommunication, a microstrip antenna (also known as a printed antenna) usually is an antenna fabricated using photolithographic techniques on a printed...

Microstrip is a type of electrical transmission line which can be fabricated with any technology where a conductor is separated from a ground plane by...

isolation between adjacent traces can be achieved more easily than with microstrip. Stripline provides for enhanced noise immunity against the propagation...

In nuclear electronics, a microstrip detector is a particle detector that consists of a large number of identical semiconductor strips laid out along one...

Ports are where an external waveguide or transmission line, such as a microstrip line or a coaxial cable, connects to the device. For a three-port circulator...

the high-frequency characteristics of the microstrip into account. When a pulse is launched into the microstrip by the transmitter, its amplitude depends...

Microstrip-line band-stop filter is convenient to implement with low cost and light weight. Hsieh & Wang (2005) stated that, conventional microstrip band-stop...

original type of microstrip antenna described by Howell in 1972. The two metal sheets together form a resonant piece of microstrip transmission line...

filter with band-stop (notch) characteristics, most commonly used with microstrip transmission lines. Spurlines usually exhibit moderate to narrow-band...

(DGS) is a purposefully-created defect on the ground plane of a printed microstrip board. It is typically created in the form of an etched-out pattern on...

Electromagnetics Lab from 1982 to 1990. Lo had served as a distinguished lecturer in microstrip antenna theory. In 1986, Lo was elected to the National Academy of Engineering...

stripline, and is one of the four main types in modern use, along with microstrip, suspended stripline, and coplanar waveguide. All four of these types...

fellow. Pozar's research interests focus on the design and analysis of microstrip antennas and phased arrays. He has authored multiple books on antenna...

common return conductor, typically the cable shielding. Likewise, multiple microstrip circuits can all use the same ground plane for the return path. This compares...

Simplified schematics of YIG-resonator coupling to microstrip network...

constructed either from hollow conductive waveguides or on a stripline or microstrip substrate. They are commonly used for beamforming in radar applications...

but horn antennas, slot antennas and lens antennas are also used. Flat microstrip antennas are being increasingly used in consumer devices. Another directive...

compatible with high-frequencies. Unfortunately, above 10 GHz, the well known microstrip and coplanar lines technologies cannot be used because they have high...

far fewer phase shifters than other methods and can be implemented in microstrip on a low-cost printed circuit board. The antenna elements fed by a Butler...

areas such as wave propagation, impedance transformations, filters and microstrip printed circuit board design.[citation needed] Radio electronics is concerned...

pair), coaxial cable, and planar transmission lines such as stripline and microstrip. The higher the frequency of electromagnetic waves moving through a given...

devices for its space saving properties. PIFAs can be printed using the microstrip format, a widely used technology that allows printed RF components to...

"Fractal-based multi-band microstrip filters", ch. 6 in, Crnojević-Bengin, Vesna (ed), Advances in Multi-Band Microstrip Filters, Cambridge University...

metalized on one or both sides. The feedline excites an open space via a microstrip line or coaxial cable, and may be terminated with either a sector-shaped...

transmission lines can be laid out in a planar form such as stripline or microstrip with carefully controlled dimensions to assure a consistent impedance...

manufacturing techniques. The structures shown can also be implemented using microstrip or buried stripline techniques (with suitable adjustments to dimensions)...

Power divider in microstrip technology...

Differential pairs include: Twisted-pair cables, shielded and unshielded Microstrip and stripline differential pair routing techniques on printed circuit...

disadvantages are their bulk and cost when compared with technologies such as microstrip filters. There is a wide array of different types of waveguide filters...

way this strong field region is created. Examples of MPGDs include the microstrip gas chamber, the gas electron multiplier and the Micromegas detector....