amplifier can enhance both the load capacity and switching speed. Push–pull outputs are present in TTL and CMOS digital logic circuits and in some types...

Look up push-pull in Wiktionary, the free dictionary. Push–pull may refer to: Push–pull output, type of electronic circuit Push–pull converter, in electronics...

configurations thus differ from push–pull outputs, which use a pair of transistors to output a specific voltage or current. These open outputs configurations are often...

remainder of the cycle, the output power is supplied by energy stored in inductors or capacitors in the power supply. Push–pull converters have steadier...

other pins that can only act as a push–pull output, and a few pins that can only act as an open collector input/output. A typical modern microcontroller...

timer) can be reset at any time. Output: The output of the latch is followed by an output stage with push–pull output drivers that can supply up to 200 mA...

being differentially driven to form a push–pull output stage, driving a push–pull transformer load. This output stage makes much better use of the transformer...

typically single-ended, requiring just a single device. The usual push–pull output configuration for class-AB and -B amplifiers requires two connected...

basis of outputs, comparators can also be classified as open-drain or push–pull. Comparators with an open-drain output stage use an external pull-up resistor...

transconductance amplifiers (OTA), each having differential inputs and a push-pull output. Linearizing diodes at the input can optionally be used by applying...

single-ended output stages, such as in single-ended triode amplifiers) or devices (for push-pull output stages), such as the class of operation of the output devices...

base-emitter junction voltage. It is commonly used in the biasing of push-pull output stages of amplifiers, where one benefit is thermal compensation: The...

set a performance standard of 0.1% THD the Ultra-Linear output stage (a tapped push-pull output transformer providing power intermediate between triodes...

A shunt regulated push-pull amplifier is a Class A amplifier whose output drivers (transistors or more commonly vacuum tubes) operate in antiphase. The...

pull-up or pull-down resistor to a voltage source, or can be applied to push-pull outputs by using diode logic (with the disadvantage of incurring a diode drop...

have a push–pull output stage. Advantages of OCL amplifiers over capacitor-coupled amplifiers include Avoiding the cost and bulk of an output capacitor...

Totem Pole Park, in Rogers County, Oklahoma Totem pole output, also known as a push-pull output, a type of electronic circuit The Totem Pole (Tasmania)...

was a turning point in audio power amplifier design, operating a push-pull output circuit in class AB1 to give performance surpassing its contemporaries...

open-drain mode when necessary for compatibility, but switches to push-pull outputs whenever possible, and includes protocol changes to make it possible...

often used in the push-pull output stages of the power audio amplifiers that drive most sound systems. In a fully symmetrical push-pull circuit two Darlington...

/ push–pull outputs Schmitt-trigger inputs / push–pull outputs Normal inputs / open-collector outputs Schmitt-trigger inputs / three-state outputs AND-OR-invert...

a piece of exercise equipment that provides resistance as the user pushes, pulls, or otherwise moves the sled along a flat surface. Commercial sleds...

inflation Cost-push inflation Demand shock Triangle model Demand-pull theory Barth, J. R.; Bennett, J. T. (1975). "Cost-push versus Demand-pull Inflation:...

problem with the high output resistance of the simple output stage the second schematic adds to this a "totem-pole" ("push–pull") output. It consists of the...

supplies) and a variety of other low duty, low frequency applications. Push-pull outputs (e.g., TTL) typically are used for direct interface to logic circuitry...

circuits List of 7400-series integrated circuits Push–pull output, open drain output, Three-state output Schmitt trigger input Programmable logic device...

single-ended common emitter voltage amplification stage, and a class B push-pull output follower with a current-sensing overload protection. There are four...

amplifiers in common use have a push-pull output configuration in their power section, with matched pairs of tubes driving the output transformer. Power amplifier...

factors or "push factors") or in the country of destination (attraction factors or "pull factors"). "Push-pull factors" are the reasons that push or attract...

simplified) design as found in modern amplifiers, with a class-AB push–pull output stage, and uses some overall negative feedback. Bipolar transistors...