CONFIG.SYS is the primary configuration file for the DOS and OS/2 operating systems. It is a special ASCII text file that contains user-accessible setup...

Windows 9x. CONFIG.SYS is a text file that contains various configuration options and specifies what device drivers will be loaded. COUNTRY.SYS is a binary...

in CONFIG.SYS. In DR DOS 5.0 (1990) and 6.0 (1991), the driver is named HIDOS.SYS rather than HIMEM.SYS, like the corresponding DCONFIG.SYS or CONFIG.SYS...

primarily relied on the CONFIG.SYS config file; a plain text file with simple key–value pairs (e.g. DEVICEHIGH=C:\DOS\ANSI.SYS). MS-DOS 6 introduced the...

Windows Me ignores this. If the CONFIG.SYS file does not exist, the IO.SYS file loads the drivers IFSHLP.SYS, HIMEM.SYS and SETVER.EXE. Windows reserves...

system files IO.SYS and MSDOS.SYS were combined into a single file IO.SYS whilst MSDOS.SYS became a configuration file similar to CONFIG.SYS and AUTOEXEC...

time. This can be emulated under DR-DOS by utilizing the CONFIG.SYS directive SET like SET CONFIG=1. %CMDLINE% (introduced with 4DOS, also supported since...

in CONFIG.SYS, and programs were loaded in the AUTOEXEC.BAT file. Some devices, such as mice, could be loaded either as a device driver in CONFIG.SYS, or...

available. Processes the MSDOS.SYS file with Windows 9x. Processes the CONFIG.SYS file, in MS-DOS 2.0 and higher and Windows 9x. Loads COMMAND.COM (or other...

versions 3.1 and later and IBM PC DOS releases 3 and later. Used in the CONFIG.SYS file to set the maximum number of drives that can be accessed. The command...

NANSI.SYS and ANSIPLUS.EXE to attempt to change this.[independent source needed] To use ANSI.SYS under DOS, a line is added to the CONFIG.SYS (or CONFIG.NT...

let the hook run. A 16-bit driver called IFSMGR.SYS would previously have been loaded by CONFIG.SYS, the job of which was to hook MS-DOS first before...

loading of an appropriate CD-ROM device driver (example: OAKCDROM.SYS), usually from CONFIG.SYS. The final version of the MSCDEX program was 2.25,[citation...

long as Scroll Lock remains activated. DR-DOS 7.02 and higher provides a CONFIG.SYS directive named SCROLLOCK=ON|OFF to change the Scroll Lock status on the...

Klangstabil feat. S.alt, Somatic Responses, Hypnoskull, Winterkälte, Config.Sys, Tarmvred, Roger Rotor, Deutsch Nepal, Placid, Panacea vs. Needle Sharing...

Early versions of SmartDrive were loaded through a CONFIG.SYS device driver named SMARTDRV.SYS. Versions 4.0 and later were loaded through an executable...

files, CONFIG.SYS and AUTOEXEC.BAT, is bypassed at startup and essential real mode drivers like HIMEM.SYS and SMARTDRV.EXE are embedded into IO.SYS. The...

code itself is required and it is loaded via an "IFS=" statement in the CONFIG.SYS file. It is a NE 16-bit dynamically loaded library. No matter if it is...

loaded in CONFIG.SYS via DEVICE statements, e.g. RAM disks. Assign subsequent drive letters to any dynamically loaded drives via CONFIG.SYS INSTALL statements...

(with DEBUG=ON and a debugger loaded before or from within CONFIG.SYS) and more flexible CONFIG.SYS tracing capabilities via the F5/F6/F7/F8 hotkeys and the...

config.sys + autoexec.bat or hold F8 so DOS prompt Y/N to confirm each line in config.sys and autoexec.bat; allowing you to skip loading qemm386.sys,...

in Unix), the output of Autotools; used to detect system configuration CONFIG.SYS, the primary configuration file for DOS and OS/2 operating systems Configuration...

to: install (Unix), a command line tool for installing files INSTALL, a CONFIG.SYS directive Installation (disambiguation) This disambiguation page lists...

file type. For example, COUNTRY.SYS is not a DOS device driver, but a binary NLS database file for use with the CONFIG.SYS COUNTRY directive and the NLSFUNC...

illusion of frozen, or slowly progressing, time in motion video TIMESLICE, a CONFIG.SYS configuration directive in OS/2 A Slice at a Time, science fiction story...

changed and overridden using the LPT1, LPT2, LPT3 (and optionally LPT4) CONFIG.SYS directives. DOS-based systems make the logical parallel ports detected...

to allow other operations to occur. The BUFFERS command/statement in CONFIG.SYS of DOS. The buffer between a serial port (UART) and a modem. The COM port...

The magic SysRq key is a key combination understood by the Linux kernel, which allows the user to perform various low-level commands regardless of the...

Windows and OS/2 systems IBMBIO.COM IO.SYS — starts the command processor as the first process SHELL (CONFIG.SYS directive) — to override default command...

codes at least in CONFIG.SYS. With 4DOS and DR-DOS COMMAND.COM, exit codes (in batchjobs) can be set by EXIT n and (in CONFIG.SYS) through ERROR=n. Exit...