electronics, a two-port network (a kind of four-terminal network or quadripole) is an electrical network (i.e. a circuit) or device with two pairs of terminals...

delta networks are effectively three port networks and hence require three simultaneous equations to fully specify their equivalence. Some two terminal...

In computer networking, a port is a communication endpoint. At the software level within an operating system, a port is a logical construct that identifies...

private network destination. RFC 2663 uses the term network address and port translation (NAPT) for this type of NAT. Other names include port address...

a two-port network also must incorporate a CCCS, that is, the appropriate choice for feedback network is a g-parameter two-port. Here the two-port method...

h-parameters. Network analyzers are often used to characterize two-port networks such as amplifiers and filters, but they can be used on networks with an arbitrary...

two-port networks. These can be represented by simple equivalent circuits of impedances and dependent sources. To be analyzed as a two port network the...

into a port of a network. Usually a two-port network is implied but the concept can be extended to networks with more than two ports. The definition of...

amplifier. In a more general case where the amplifier is represented by a two-port network, the input resistance of the amplifier depends on its load, and the...

through the ports (of a two-port network in this case) respectively. A Z-parameter matrix describes the behaviour of any linear electrical network that can...

temperature in a two-port network or amplifier that will result in the same output noise power, when connected to a noise-free network or amplifier, as...

measured in terms of power (except in now-obsolete six-port network analyzers). Modern vector network analyzers measure amplitude and phase of voltage traveling...

This is a list of TCP and UDP port numbers used by protocols for operation of network applications. The Transmission Control Protocol (TCP) and the User...

Y-parameter matrix for the two-port network is probably the most common. In this case the relationship between the port voltages, port currents and the Y-parameter...

In computer networking, port forwarding or port mapping is an application of network address translation (NAT) that redirects a communication request from...

of two-port networks and their cascades, propagation constant measures the change undergone by the source quantity as it propagates from one port to the...

security policies of their networks and by attackers to identify network services running on a host and exploit vulnerabilities. A port scan or portscan is a...

port of the hub except the port on which the packet was received, unable to distinguish different recipients, and achieving an overall lower network efficiency...

which can be confusing at occasions. The operating power gain of a two-port network, GP, is defined as: G P = P L P I {\displaystyle G_{P}={\frac {P_{\mathrm...

electrical theorem in network analysis attributed to Albert Charles Bartlett. The theorem shows that any symmetrical two-port network can be transformed...

combination of two or more two-port networks (or quadripoles) in electrical circuit analysis. The test determines whether the network still meets the port condition...

y-parameter two-port network. Vin is the input of the circuit and V2 is the output. The two-port equations impose a set of linear constraints between its port voltages...

antimetry of a network usually refer to the input impedances of a two-port network when correctly terminated. A symmetric network will have two equal input...

not it can be constructed as a lossless rational two-port network. Lossless implies that the network contains only inductances and capacitances – no resistances...

technique based upon two-port networks. For example, in an application like this one where voltage is the output, a g-equivalent two-port could be selected...

Generally, in a two-port network, for a finite input, there exists an output. However, when zero output occurs for finite input, the network is said to have...

In electrical circuit theory, a port is a pair of terminals connecting an electrical network or circuit to an external circuit, as a point of entry or...

Jan Verspecht and Dr. David E. Root. Two-port network Dr. Jan Verspecht (December 2005). "Large-Signal Network Analysis" (PDF). IEEE Microwave Magazine...

a two-port electrical wave filter in which diagonally-crossed shunt elements are present – a configuration which sets it apart from ladder networks. The...

significantly faster recovery in response to network changes or failures, introducing new convergence behaviors and bridge port roles to do this. RSTP was designed...