carriers injected into the emitter–base junction must come from the emitter. The low-performance "lateral" bipolar transistors sometimes used in CMOS processes...

A multiple-emitter transistor is a specialized bipolar transistor mostly used at the inputs of integrated circuit TTL NAND logic gates. Input signals...

inputs are the emitters of bipolar transistors. In the case of NAND inputs, the inputs are the emitters of multiple-emitter transistors, functionally equivalent...

the base and the emitter, can control or switch a much larger current between the collector and emitter. A field-effect transistor (FET) has terminals...

replacement of a transistor. Due to the Early effect, the current gain is affected by the collector–emitter voltage. Both gain and base–emitter voltage depend...

Branch of chemistry and electronics Organic light-emitting transistor – form of transistor that emits lightPages displaying wikidata descriptions as a...

open emitter, and open source refer to integrated circuit (IC) output pin configurations that process the IC's internal function through a transistor with...

RGB tri-color Tri-color LEDs contain three different LED emitters in one case. Each emitter is connected to a separate lead so they can be controlled...

emitter-coupled logic (ECL) is a high-speed integrated circuit bipolar transistor logic family. ECL uses an overdriven bipolar junction transistor (BJT)...

The field-effect transistor (FET) is a type of transistor that uses an electric field to control the flow of current in a semiconductor. It comes in two...

created using NAND gates alone. In TTL ICs using multiple-emitter transistors, it also requires fewer transistors than a NOR gate. As NOR gates are also functionally...

A transistor is a semiconductor device with at least three terminals for connection to an electric circuit. In the common case, the third terminal controls...

source transistor and an NPN common emitter open collector inverter transistor (i.e. they are connected to the GND). On a wafer, these two transistors are...

signal waveforms. An emitter follower is a type of non-inverting amplifier, indicating that the signal at the emitter of a transistor is following (that...

second common collector stage Q2 (an emitter follower) through the voltage divider R1-R2. The emitter-coupled transistors Q1 and Q2 actually compose an electronic...

modification of the basic two-transistor current mirror that incorporates an emitter degeneration resistor for only the output transistor, enabling the current...

between the collector and emitter, controlled by the base-emitter current. Another type of transistor, the field-effect transistor (FET), operates on the...

heated, directly heated) and warm-up time (including "bright-emitter" or "dull-emitter") by characteristic curves design (e.g., sharp- versus remote-cutoff...

a multiple-independent-gate field-effect transistor (MIGFET). The most widely used multi-gate devices are the FinFET (fin field-effect transistor) and...

two-transistor current mirror with emitter degeneration. Negative feedback is a basic feature in some current mirrors using multiple transistors, such...

increase in the collector–emitter voltage to observe KVL), the transistor's base–emitter voltage (UBE) increases, turning the transistor on further and delivering...

logic (RCTL) Emitter-coupled logic (ECL) Positive emitter-coupled logic (PECL) Low-voltage PECL (LVPECL) Complementary transistor micrologic (CTuL)...

transistor) Composite transistors BiCMOS (bipolar CMOS) IGBT (Insulated-gate bipolar transistor) Other transistors Bipolar junction transistor (BJT...

usually presented in transistor datasheets as a graph with VCE (collector-emitter voltage) on the abscissa and ICE (collector-emitter current) on the ordinate;...

in large quantities. This standardization began in the era of discrete transistor mainframes and minicomputers, and has rapidly accelerated with the popularization...

common transistors and diodes?". EDAboard.com. 2010-06-10. Archived from the original on October 11, 2007. Retrieved 2010-08-06. I.D.E.A. "Transistor Museum...

signals. Light occurring on an optical transistor's input changes the intensity of light emitted from the transistor's output while output power is supplied...

through two bipolar transistors with different emitter areas. By the Ebers–Moll model of a transistor, The transistor with the larger emitter area requires...

the base/emitter and the output is the change in collector current flowing between the collector/emitter with a constant collector/emitter voltage. The...

electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These...